Overall Equipment Effectiveness (OEE) is used to monitor manufacturing effectiveness.
The resulting OEE percentage is generic and allows comparisons across differing industries.


Availability = Actual Runtime / Production Time

OEE Availability is the ratio between the actual runtime and planned production time. The planned production time does not include breaks, lunches, and other pre-arranged time a production line or process may be down.

If a line is run for one 8-hour shift with two 15-minute breaks and one 30-minute lunch, then the planned production time is 7 hours (determined from 8 hours – 15-minute break – 15-minute break – 30-minute lunch). If during the production run, there are 25 downtime events totaling  45 minutes of downtime, then the runtime is 6 hours, 15 minutes (derived from 7 hours of scheduled time – 45 minutes). The OEE Availability equals 89%,  calculated from actual runtime divided by the scheduled runtime, or 6 hours, 15 minutes divided by 7 hours.


Performance = Actual Number of Units Started / (Standard Rate x Actual Runtime)


OEE Performance is the ratio between the actual number of units started (not the number that have been produced) and the number of units that theoretically can be processed based on the standard rate. The standard rate is the rate the equipment is designed for. Performance is not based on the number of units produced, but, on what the line was designed to process over a given period of time.


If a work cell is designed to process 10 units per minute, we can calculate the theoretical amount of units it can process in a given amount of time. Using the 6 hours, 15 minutes of actual runtime from the above example, a total of 3750 units would be processed (or started). Calculated from taking 6 hours, 15 minutes (375 minutes) times 10 units per minute. If the actual number of units processed is 3000, then OEE Performance is 80% (calculated by 3000 / 3750).


Quality = Good Units Produced / Actual Number of Units Started

OEE Quality is the ratio between good units produced and the total units that were started.


Taking the number of units produced from above of 3000, if 200 units were rejected at the quality inspection station, then 2800 good units are produced. The OEE Quality is 93% calculated from 2800 divided by 3000.


OEE = Availability x Performance x Quality

This is the final calculation that measures Overall Equipment Effectiveness.

Using all the numbers from above, 89% x 80% x 93% = 66%.

This may seem like a low number but it is important to keep in mind that the OEE is not to be compared to 100%. The OEE result from this production run is compared to other production runs; however, using Sepasoft’s OEE Downtime and Scheduling module allows much more than just comparing OEE results between production runs. It allows you to compare OEE results between operators, shifts, products, or other factors you define (e.g. raw material vendor, humidity, etc.).

OEE is a well-established performance metric that takes into account Equipment Losses usually broken into the following categories: Availability Loss, Performance Loss, and Quality Loss; measuring Performance with respect to Planned Production Time.